|
|
Post by bmartin359 on Nov 8, 2017 19:46:54 GMT -5
Up next, well after I finish a 1953 Corvette I am working on, is Dale Jr's 2017 Mountain Dew car. Decals from Stoneys. I hope it turns out well. The Kit and decals  What I hope to be the end result  |
|
|
|
Post by tireman33 on Nov 11, 2017 18:30:21 GMT -5
Good luck and keep us posted on your progress
|
|
|
|
Post by bmartin359 on Nov 18, 2017 15:36:33 GMT -5
Now that the corvette is behind me got some time to put in on the Michigan build. Here is the progress on the dash. First time I noticed that Revell molded padding the full length of one the roll bars. Next build I will be sanding that section down to be more accurate. I stretched sprue for the switches for most of the them and drilled a holes in the dash to give them a little more security. My next build will have a carbon fiber dash as well.   |
|
|
|
Post by drjekyll76 on Nov 18, 2017 20:43:02 GMT -5
looking good
|
|
|
|
Post by bmartin359 on Nov 18, 2017 23:49:38 GMT -5
|
|
|
|
Post by bmartin359 on Nov 19, 2017 23:57:04 GMT -5
|
|
|
|
Post by bmartin359 on Nov 22, 2017 22:35:39 GMT -5
|
|
|
|
Post by hotwheels on Nov 23, 2017 8:02:51 GMT -5
Great job..  it turned out nice |
|
|
|
Post by Reyst on Nov 23, 2017 8:48:28 GMT -5
Looksngreat
|
|
|
|
Post by tireman33 on Nov 23, 2017 9:16:44 GMT -5
Nice build
|
|
|
|
Post by bmartin359 on Nov 23, 2017 12:52:42 GMT -5
Thank you guys
|
|
|
|
Post by chaseelliott9 on Nov 23, 2017 21:50:47 GMT -5
Looks great I have a questionhow do u lower these
|
|
|
|
Post by bmartin359 on Nov 23, 2017 23:12:48 GMT -5
Yes, I try and lower them. I trim the mounting rods a little bit on the rear and then on the front I just glue the wheels in place and work to eyeball the ride height. I have heard that cutting the windows apart will also give a little room for the rollcage to sit higher into the body.
|
|
it turned out nice
