Post by Pheedens I am on Apr 17, 2018 22:19:48 GMT -5
My skills ran out and so did I my cares with this one at the end, the suspension is very finicky and over complicated, the springs are very tough and a few pushes down and you will probably break things, I broke some of the parts trying to get them to snap into place, the rear shocks are real pain in the butt, its best to glue everything and call it day.
The body is another pain, the front of the sides had to be bent inwards because they were too straight , and I snap the left side in half, the windshield frame needs to sit farther back then the mounting points, its struggle to get it back and I was able to get the left side back, the glued dried before I could the right side. So, that made the hood mounting tabs not line up with the holes, getting the grill into place was a real pain, OMG. The fender flares if you will dont fit real on the front, and those are paint to get to sit into place.
As you can see, the roof/doors dont fit very well, the would better if I glued them on, but even then.
This was way over complicated for now real reason, and my skills were not good enough for this one.
I am embarrassed to say I built this
Painted with Jeep Anvil
The body is another pain, the front of the sides had to be bent inwards because they were too straight , and I snap the left side in half, the windshield frame needs to sit farther back then the mounting points, its struggle to get it back and I was able to get the left side back, the glued dried before I could the right side. So, that made the hood mounting tabs not line up with the holes, getting the grill into place was a real pain, OMG. The fender flares if you will dont fit real on the front, and those are paint to get to sit into place.
As you can see, the roof/doors dont fit very well, the would better if I glued them on, but even then.
This was way over complicated for now real reason, and my skills were not good enough for this one.
I am embarrassed to say I built this
Painted with Jeep Anvil
